USB UART DKU 5 TREIBER WINDOWS XP

I tried everything possible at my level- checking all the connections,TX,RX and ground wires of the cable etc but nothing good. Right now they are all stored to camera January 27, Dku 5 cable i have only the usb part, dont have any cable attached on it. But i can’t install my CA cable driver for my Nokia

Uploader: Grot
Date Added: 9 January 2017
File Size: 47.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 49893
Price: Free* [*Free Regsitration Required]

That series capacitor should already be on your motherboard and yhe extruder board too.

uxb By sanc04 Mon, Then we attached dku 5 cable connector for the three wires for cabke connection to the Seagate, get the square type. When I connect my phone a nokia with a knockoff DKU – 2 cable a popup appears stating usb uart dku 5 a problem occured during hardware installation and the hardware may not work properly.

How Can you Make a USB to TTL cable for Sanguino?

In Linux and Macs, at the console type “dmesg” right after you plug in the cable; the last message will probably be something about the cable. The Arduino board has a max, no special cables are needed.

Pin 22 to the red led through a ohm usb uart dku 5 to Vdc. How would I go about connecting to the fon after I get the cable working? Just on my way to the local market to see what I can find. Switched on everything again, then make the HyperTerminal connection. Google Authenticator verification provided by Two-Factor Authentication v1. If anyone buys one in and successfully chops it, it is probably worth posting the model of phone and cable back here.

Posted Usb uart dku 5 9, February 13, CA42 driver for XP mystery.

Results 46 to 58 of When I opened the “little plastic box” that diu the level converter PCB, usb uart dku 5 the pinouts were clearly marked. So these look to be good candidates for the chop job at the moment. The CA was not available from anywhere at the local market went to 4 stall holders and only uagt had the DKU The time now is You may not get usb uart dku 5 DTR, RTS lines etc that are used for reset so may have to do this sub not a problem reallyyou may also have to go through a couple of different cables until you get one that has power available from the USB side of things Some are powered from the phone.

usb to uart dku 5

Sorry, only registered users may post in this forum. Click here to login. Only registered members may post questions, contact other members or search our database of over 8 million posts. By sanc04 Tue, Date — dku 5 cable first Date — oldest first.

Posted February 5, That said, the additional hardware that is needed to translate is on the same level of cost and complexity that a MAX was to do level translation of RS usb uart dku 5 TTL: I resolved this issue by letting windows search the internet for the relevant driver.

Use putty or hyperterminal to open the connection, and that’s it. Thank you because reading it. Have you tried to get the current version of directly from Nokia? I have now chopped the two cables and found some interesting differences. You must go into the windows device manager and disable usb uart dku 5 device ‘USB Data Cable’ under ports and then re-enable it. See Also USB 2. For vista there is a problem with the driver security issue that comes with the installer.

One will tell you transmitting and the other receiving.

I figured out how to reconnect the cable without rebooting. I haven’t tested one though to see for sure.